C H A P T E R 2 5
Modem Setup Service
25-8
Defining a Modem Setup
Note
You can only set the service class (use the
kServiceClass
constant) for versions of the software that support the Class 2 fax
protocol. Newton System Software version 2.1 and the German
version of Newton System Software version 2.0 support the Class
2 fax protocol.
protocol. Newton System Software version 2.1 and the German
version of Newton System Software version 2.0 support the Class
2 fax protocol.
For detailed descriptions of these constants, see "Fax Profile Constants"
(page 22-10) in Newton Programmer's Reference.
(page 22-10) in Newton Programmer's Reference.
The constants that you can use to specify speeds in defining your fax profile values
are shown in Table 22-5 (page 22-11) in Newton Programmer's Reference.
are shown in Table 22-5 (page 22-11) in Newton Programmer's Reference.